Raised in California and transplanted to Utah. Married my college sweetheart from Montana, and we are raising 4 nuggets together. I love all things DIY projects and doing them on a budget. I don’t mind messing up and am ok with the 90/10 rule - nothing is perfect over here and it’s fine by me! Encouraging all ‘wanna-be’ DIYers to just get out there and try it! You will be so glad you did.”
EEK! I am geeking out at my newest project – like hardcore. I LOVE IT, I LOVE IT, I LOVE IT! Did I mention that I love it? Ok. Want to see my before and after?
Amazing right? So here we go….
I discovered Weaber Lumber (pronounced Webber) on Instagram after seeing some amazing walls finished with it and I had to try it out. I am renovating my guest room and it was the perfect wall to do it on. So check out my 60 second video tutorial and then follow along and see how easy it is for anyone to do this DIY!
We do use affiliate links to help our readers find the products we use. We hope this helps!
There are so many wood boards on the market for your home. We have used shiplap – ripped plywood (read about our post here), vinyl flooring, real wood flooring and peel and stick. This was our first time trying already weathered real wood pieces and we loved it. Mainly because the prep work is ZERO. Now you need to be aware that this is super raw wood. So if you are planning on putting it in a place where it will get dirty and you will do lots of cleaning, you will need to sand it down and add a top coat for protection. Where it was going in this spare room with little chance of marks, we decided to keep it in its raw form.
Step One: Find Your Studs
You will need to be adding this wood into the studs of your wall. Just grab your stud finder and get to work. Mark where the red line appears (usually every 16 inches). Then you will play connect the dots and draw vertical lines down the wall so you can see as you go where to nail.
Step Two: Prep Your Nail Gun
You will load your gun WHILE IT IS UNPLUGGED. Safety first my friends! Then attach it to your air compressor and get ready for some fun! Here is a photo step by step process.
Step Three: Get Your Wood and Start Nailing
They sell this wood at The Home Depot in 2 different shades for $25 a box. Each box contains 10.5 square feet.
It’s that easy! Yes, you might want to wipe down your wall first, but if it’s covered up I didn’t worry about old marks. You will have to use your judgement on the lengths of boards you use so that you don’t have too symmetrical of a wall.
The directions are right on the box. You can’t go wrong.
You will want to make sure that the boards are level as you start, because not all ceilings and wall lines are!
Change up the lengths a bit as you see I have done. You can also hang them vertically if you want that look.
Use your circular saw to cut the boards to fit areas you have measured out with your measuring tape. You should always wear glasses – I was cheating here.
Step Four: Use Your Scraps!
This wood is so awesome you will not want any to go to waste. I had extras so I did the window box as well.
Clean up and you are done! See how easy?