How to add a Laundry Room Table – One Room Challenge Week 5

My One Room Challenge Laundry Room Renovation is just about finished – welcome to Week 5! I am so grateful to Kirkland’s for sponsoring this project, they have the most amazing laundry room pieces – check those out here!

 

Make sure to check out the One Room Challenge Blog to see all the updates of the designers participating – their feeds are so inspiring.

Here is a recap of my 6 week outline:

Week One – OrigInal Room Reveal (read here)
Week Two – Wood Ceiling (READ HERE)
Week Three – Wallpaper and Cupboards (read here)
Week Four – Floating Shelves (read here)
Week Five – Drying Racks and Folding Table
Week Six – Decorations and Reveal
This post contains affiliate links to help you navigate to products I have used and am showcasing.

It was now time for me to build a table to cover the washer and dryer to fold my clothes on. My space is limited and I needed all the usable area I could get. This ended up being super easy and very effective for me.

Step One – Shop

I wanted butcher block, but it was out of my price range. You can build a butchers block board, but in the end I decided to use 1×8 pine boards instead.

I measured a 66 inch length and a 30 inch depth in my area. This required four 1×8 boards at 6 feet long and one 1×4 board (this is for the back edge of the folding table).

You can have Home Depot cut them for you as well.

Step Two – Cut and Mount

Cut each of your boards to the length you need. You will then add pocket holes to 3 of the 1×8 boards (read how to do that here).

Attach your boards together, using wood glue and pocket hole screws size 1 1/4 inch. Use clamps to make sure your boards are fitting snug. I also used extra weight on the boards as I attached them together to make sure they were flat when they were screwed together.

You will then add the 1×4 board to the back of the boards. You can use screws right into the back since noone will see these.

Step Three – Sand

Sand down your folding table. I used my Tacklife sander that is from Amazon ($25!). I actually sanded the 1×8 boards first before I mounted the 1×4 board. Additionally I had sanded the 1×4 board seperately. You can do what works for you.

Step Four – Stain

Add the stain of your choice. I used Old Barn Living Weathered One Step Stain – it’s one of my favorites and matched the other shelving in the room. I used 2 coats and then added a top coat.

Step Five – Add Braces

You will lay the folding table onto 2 braces. These are 2×3 boards that are mounted to the wall into the studs. Measure where your studs are, then mark that spacing onto the board and pre-drill your 3 1/2 inch screws into them.

Use a level to mount these into the wall. Make sure they are level!!

Step Six – Add Table

You will gently slide your table onto the 2×3 boards. We added a 1×10 board underneath our table for stability because we didn’t want it sitting on top of the washer and dryer.

Add screws or brad nails into the sides of the table and into the 2×3 boards. Then you are all finished!!

Next week I will showcasing all of the amazing pieces I have picked out from Kirkland’s to finalize this space.  I can’t wait to share it with you!

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.